![]() ![]() Should be made more clear/automatic for less advanced users though. HDDs are the most common type of storage device in modern computers, and are also used in many other devices, including. A hard disk drive (HDD) is a data storage device that stores digitally encoded data on rapidly rotating platters with magnetic surfaces. Maybe the wiring to the header isn't quite right. Best Buy customers often prefer the following products when searching for led hard disk. Thank you sir! I will try what you suggested regarding the fan as soon as I can.ĭoes the inbuilt HDD LED not blink for you? I feel like the board might not think I have my HDD LED wires connected. Turn SenseMI skew to "Disabled" on a 1700 (which I have) or temperatures can appear to be all over the map when they ain't. I'm using CHA2 in PWM with a pair of Noctua NF-F12 fans for my fron intakes using Noctua's Y-cable and it works fine. Try some different configurations for that. If it spins up properly then the port is probably fine but it's not seeing the feedback from the fan for some reason. It's a radio button under the graph for that, than click "apply". Set fan channel 2 to "DC" and then select the maximum all the time. Go into the BIOS and set up the "Q-fan" system. Loving the board so far, apart from these little issues I assume I keep it off, however it would be nice if the motherboard could automatically detect whether this option should be enabled or disabled after a CPU install. When set to 'Disabled', I see a max of around 64C. When set to auto, my temps never go higher than 49C. I'm a bit confused about the 'Sense MI Skew' settings & how I should set it using a 1700. The fan works using an external fan controller or a different port on the motherboard.Īny quick fixes for this? If the port is dead I'll probably just go back to using my controller.Īnd finally. This is pretty annoying, can it be disabled? I had a look through the BIOS but couldn't find anything.Īlso, my fan connected to 'CHA2' barely spins & is not detected in Windows. However, a big orange HDD LED also flashes on the bottom right of the board whenever the HDD light on my case is. I have all of my front header LED & switches plugged in, and they work fine. The System x blades connected to the HDDs will have their green activity LEDs normally off and blink when active. I'm using 3200Mhz Corsair LPX at 2133 & a 1700. The Hard Disk Drives (HDDs) installed in a disk enclosure connected to a BladeCenter with mixed JSXX, HSXX, and LSXX blades can have different behaviors in their activity Light Emitting Diodes (LEDs). Just bought my first ROG motherboard, the X370 Hero, and I have a couple of questions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |